![]() Whatever you set up on the front panel can be stored - including assignment of the pedal treadle, if not used for wah or volume, to a particular effect parameter. The ToneLab ST has 100 memory patches on board, comprising 50 factory presets and 50 slots to store your own sounds. At the end of the signal chain a single rotary knob offers varying degrees of spring, room and hall reverb. The next stage in the chain - the modulation/delay effect, again with 11 effects choices - has two editable parameters adjustable by a rotary knob or, where appropriate, a Tap Tempo button. Whatever pedal is chosen has one major parameter that can be adjusted. There are 11 choices of pedal to start off the signal chain, these include five different overdrive/distortion/fuzz choices, treble boost, compressor, wah, octaver, Univibe and an acoustic simulation. While in this mode the treble knob adjusts presence and the middle knob turns on and sets the amount of noise reduction. One of 11 cabinets can then be selected using the gain knob - the number of the cabinet appearing in the ToneLab's small numeric display. Choosing a cabinet model to go with your amp is a simple matter of holding down the cabinet switch until it flashes. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |